Advidia "A" Series Manual do Utilizador descarregar pdf (Página 10)

User Manual of Network Camera

Chapter 2 Network Connection

Before you start:

 If you want to set the network camera via a LAN (Local Area Network), please refer to

Section 2.1 Setting the Network Camera over the LAN.

 If you want to set the network camera via a WAN (Wide Area Network), please .2

Setting the Network Camera over the WAN.

2.1 Setting the Network Camera over the LAN

Purpose:

To view and configure the camera via a LAN, you need to connect the network camera in the

same subnet with your computer, and install the Advidia Camera Finder software to search

and change the IP of the network camera.

Note: For the detailed introduction of Advidia Camera Finder Utility, please refer to

Appendix 1.

2.2 Wiring over the WAN

The following figures show the two ways of cable connection of a network camera and a

computer:

Purpose:

 To test the network camera, you can directly connect the network camera to the

computer with a network cable as shown in Figure 2-1.

 Refer to the Figure 2-2 to set network camera over the LAN via a switch or a router.

Figure 2-1 Connecting Directly

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 100 101

Sem comentários

Advidia "A" Series Manual do Utilizador Página 10