Advidia "A" Series Manual do Utilizador descarregar pdf (Página 5)

Advidia A Series Network Camera User Manual

Cautions:

 Make sure the power supply voltage is correct before using the camera.

 Do not drop the camera or subject it to physical shock.

 Do not touch sensor modules with fingers. If cleaning is necessary, use a clean cloth with

a bit of ethanol and wipe it gently. If the camera will not be used for an extended period

of time, put on the lens cap to protect the sensor from dirt.

 Do not aim the camera lens at the strong light such as sun or incandescent lamp. The

strong light can cause fatal damage to the camera.

 The sensor may be burned out by a laser beam, so when any laser equipment is being

used, make sure that the surface of the sensor not be exposed to the laser beam.

 Do not place the camera in extremely hot, cold temperatures (the operating

temperature should be between -30°C ~ 60°C, or -40°C ~ 60°C if the camera model has

an “H” in its suffix), dusty or damp environment, and do not expose it to high

electromagnetic radiation.

 To avoid heat accumulation, good ventilation is required for a proper operating

environment.

 Keep the camera away from water and any liquid.

 While shipping, the camera should be packed in its original packing.

 Improper use or replacement of the battery may result in hazard of explosion. Please

use the manufacturer recommended battery type.

Notes:

For the camera supports IR, you are required to pay attention to the following precautions to

prevent IR reflection:

 Dust or grease on the dome cover will cause IR reflection. Please do not remove the

dome cover film until the installation is finished. If there is dust or grease on the dome

cover, clean the dome cover with clean soft cloth and isopropyl alcohol.

 Make certain the installation location does not have reflective surfaces of objects too

close to the camera. The IR light from the camera may reflect back into the lens causing

reflection.

 The foam ring around the lens must be seated flush against the inner surface of the

bubble to isolate the lens from the IR LEDS. Fasten the dome cover to camera body so

that the foam ring and the dome cover are attached seamlessly.

1 2 3 4 5 6 7 8 9 10 ... 100 101

Sem comentários

Advidia "A" Series Manual do Utilizador Página 5